Angular Dimension | How to use? (90% Unique Way) March 2025

Hello friends, today we are learning about Angular Dimension, how do you show the symbol for angular dimensions, definition, and What is the angular dimension formula and units AutoCAD?

What is an angular dimension in AutoCAD?

Angular dimension definition: The Angular dimension apparatus estimates an angle between two objects.

To make an Angular dimension select article 1, and afterward object 2 to recognize the components making the angle.

How are angular dimensions used?

Angular dimensions measure the Angle between two lines or three points.

To measure the angle between two radii of a circle, you have to select the circle & indicate the point endpoints.

With different objects, you select the items and afterward determine the area.

You can likewise aspect a point by determining the point vertex and endpoints.

As you make the dimension, you can alter the text content and arrangement before determining the aspect line area.

Keep Note: You can make a baseline & proceed with angular dimensions compared with existing angular dimensions. Benchmark and proceed with angular dimensions restricted to 180 degrees or less.

To acquire standard and proceed with angular dimensions bigger than 180 degrees, use hold altering to extend the area of the extension line of a current pattern or proceed with dia.

Dimension Lines

Assuming that you utilize two straight, nonparallel lines to indicate a point, the dimension line circular segment traverses the point between the two lines.

On the off chance that the dimension line circular segment doesn’t meet either of the lines being dimensioned,

The program defines a couple of expansion boundaries to converge the dimension line bend. The arc is in every case under 180 degrees.

1. Dimension Circles & Arcs

• On the off chance that you utilize an arc, a circle or three focuses to determine a point, the program draws the dimension line bend between the expansion lines.
• The expansion lines are drawn from the angle point endpoints to the convergence of the dimension line arc.
• The area that you indicate for the dimension line arc decides the quadrant of the dimensioned angle.

2. Dimension to Quadrant

• Angular dimensions can gauge a particular quadrant that is framing while dimensioning the angle point between the endpoints of a line or arc, the center point of a circle, or two vertices.
• As an angular dimension is made, four potential angles will be estimated.
• Determining a quadrant permits you to guarantee that the right angle is dimensioned.
• While setting an angular dimension after a quadrant is determined, you can put the dimension text beyond the expansion lines of the dimension.
• The dimension line is naturally broad.

How do you show angular dimensions?

• Click the Annotate tab then the Dimensions panel & then the Dimension tool.
• At the prompt, enter & select (Angular).
• Select one of the below:
  1. An arc
  2. A circle & two points
  3. Two non-parallel lines
  4. A vertex & two points
• But before specifying the dimension line location, you can edit or rotate the text easily.
• Then click to place the dimension line.
• You can repeat the steps & continue dimensioning or press the Enter key to end dimensioning.

Read More: Introduction to AutoCAD. and How to use the AutoCAD command line.

FAQ on Angular Dimension

You can read our Other Articles